Telnet Access - Netopia 3341-ENT Firmware User Manual

10-20 Firmware User Guide
The ATM Circuits Configuration menu screen appears as follows:
Note:
Multiple ATM circuit configuration is supported on multiple ATM-capable gateways. Although some of
the parameters of the Circuit Configuration screens pertain to Voice and Connection Profiles, it is assumed that
if the user has been granted PVC configuration access, they are permitted configuration access to all PVC
parameters.

Telnet Access

Telnet is a TCP/IP service that allows remote terminals to access hosts on an IP network. Netopia Firmware
Version 8.7 supports Telnet access to its configuration screens.
Caution!
You should consider password-protecting or restricting Telnet access to the Router if you suspect there is a
chance of tampering.
To password-protect the configuration screens, select Easy Setup from the Main Menu, and go to the Easy
Setup Security Configuration screen. By entering a name and password pair in this screen, all access via Telnet
and SNMP will be password-protected.
To restrict Telnet access, select Security in the Advanced Configuration menu. The Security Options screen will
appear. There are two levels of Telnet restriction available:
•
To restrict Telnet access to the SNMP screens, select Enable Telnet Access to SNMP Screens and toggle
it to No. (See "SNMP traps" on page
•
To restrict Telnet access to all of the configuration screens, select Enable Telnet Console Access and
toggle it to No.
ATM Circuits Configuration
Display/Change WAN 1 Circuit...
Add WAN 1 Circuit...
Delete WAN 1 Circuit...
Display/Change WAN 2 Circuit...
Add WAN 2 Circuit...
Delete WAN 2 Circuit...
9-11.)