Ip Subnets - Netopia 3341-ENT Firmware User Manual

7-4 Firmware User Guide
• If you select IP Address Serving you will be taken to the IP Address Serving screen (see
Serving" on page
that the addresses distributed by the Router and those that are manually configured are not the same.
Each method of distribution must have its own exclusive range of addresses to draw from.
•
If you select Additional LANs you will be taken to the Additional LAN Configuration screen (see
LANs" on page 7-37). Here you can create up to six additional local area networks that can be associated
with any IP routed interface.

IP subnets

The IP Subnets screen allows you to configure up to eight Ethernet IP subnets on unlimited-user models, one
"primary" subnet and up to seven secondary subnets, by entering IP address/subnet mask pairs:
Note: You need not use this screen if you have only a single Ethernet IP subnet. In that case, you can continue
to enter or edit the IP address and subnet mask for the single subnet on the IP Setup screen.
This screen displays up to eight rows of two editable columns, preceded by a row number between one and
eight. If you have eight subnets configured, there will be eight rows on this screen. Otherwise, there will be one
more row than the number of configured subnets. The last row will have the value 0.0.0.0 in both the IP
address and subnet mask fields to indicate that you can edit the values in this row to configure an additional
subnet. All eight row labels are always visible, regardless of the number of subnets configured.
• To add an IP subnet, enter the Router's IP address on the subnet in the IP Address field in a particular row
and the subnet mask for the subnet in the Subnet Mask field in that row.
7-17). Since no two hosts can use the same IP address at the same time, make sure
IP Address
----------------
#1: 192.128.117.162
#2: 0.0.0.0
#3:
#4:
#5:
#6:
#7:
#8:
IP Subnets
Subnet Mask
---------------
255.255.255.0
0.0.0.0
"IP Address
"Additional