Wan Event History Error Reporting - Netopia 3341-ENT Firmware User Manual

6-24 Firmware User Guide
Profile Name----------Type--Rx Pckts--Tx Pckts--Discard--Remote Address--
HA <-> FA1 (Jony Fon
HA <-> FA3 (Sleve M.
My IPsec Tunnel
Bangalore
If the remote tunnel end point is a hostname (or "0.0.0.0") 0.0.0.0 is displayed until a Security Association is
established. Previously the remote members network was displayed.

WAN Event History Error Reporting

The following events are logged and displayed in the WAN Event History screen:
Event message:
IKE: no ph1 preferences assigned
IKE: DNS lookup failure
IKE: no matching ph1 profile
IKE: no matching proposal
IKE: phase 1 auth failure
IKE: phase 1 resend timeout
IKE: phase 1 complete
IKE: phase 2 hash failure
VPN Quick View
ATMP 99
ATMP 13
IPsec 23
PPTP 45
An attempt was made to use an IPsec profile with no IKE
profile attached to it.
The DNS lookup of the remote tunnel end point has failed.
An IKE phase 1 request was received and did not match
any of the profiles stored in the local Router.
An IKE phase 1 request was received and the proposal did
not match an allowed parameter, or else the remote
rejected the local Router's proposal.
The phase 1 remote authentication failed.
The attempt to resend the phase 1 remote authentication
timed out.
The phase 1 negotiation completed successfully.
The phase-2 hash failed because the data received is out
of date or has been tampered with.
99 173.166.82.8
14 63.193.117.91
12 0.0.0.0
35 1.1.1.1
Meaning: