Wg511T Default Wireless Configuration Settings - NETGEAR WG511T User Manual

User Manual for the NETGEAR 108 Mbps Wireless PC Card 32-bit CardBus WG511T

WG511T Default Wireless Configuration Settings

If this is a new wireless network installation, use the factory default settings to set up the network
and verify wireless connectivity. If this is an addition to an existing wireless network, you will
need to identify the wireless configuration and security parameters already defined.
Your NETGEAR 108 Mbps Wireless PC Card 32-bit CardBus WG511T factory default basic
settings are:
• Network Name Service Set Identification (SSID): Any (First available network)
Note: In order for the WG511T Wireless PC Card to communicate with a wireless access point
or wireless adapter, all devices must be configured with the same wireless network name
(SSID).
• Network Mode (Infrastructure or Ad-hoc): Infrastructure
• Data security WEP encryption: Disabled
The section below provides instructions for setting up the NETGEAR 108 Mbps Wireless PC Card
32-bit CardBus WG511T for basic wireless connectivity to an access point. The procedures below
provide step-by-step installation instructions for Windows PCs. Use the procedure that
corresponds to the version of Windows you are using.
Basic Setup 3-3