Cleaning And Maintenance Of The Dispensing System; Peak-Load Negotiation; Communication Module; Operating Data - Miele PW 6163 Operating And Installation Instructions

Optional modules
Cleaning and
maintenance of
the dispensing
system
52
Press the  "Save" function button.

The measured value is assigned to the pump.
Reattach the hose.

Rinse the dispensing system through with hot water every 2 weeks,
or before shutting the dispenser pumps down for any length of time,
to avoid the system getting clogged up and corroded.
Also rinse out the siphons with water.

Put the siphons in a container of warm water (40-50 °C).

Use dispenser calibration to activate each pump until the dispens-

ing system is rinsed through.
Check the connection points, hoses, dispensing sockets and wash-

ers for leaks.

Peak-load negotiation

When the peak-load function is activated, the heating is deactivated
and the programme stopped.
Activate the peak-load function.

The following message appears in the display:
1
Cottons
Prog. stopped. Peak load cut-out.
Programme will continue automatically.

The programme is resumed automatically when the peak-load func-
tion finishes.

Communication module

The machine can be connected to a PC (personal computer) using
the communication module.
The slot for the communication module is located on the back of the
machine.
An Editor programme is available for this from your sales and service
centre or your Miele dealer.

Operating data

With the Operating data module, Operating data can be read or de-
leted via the  "Operating data" button either before programme
start or at the end of the programme.
Cottons hygiene
1
2 Cottons
Cottons Intensive
3



90 °C
60 °C
60 °C

 