Show Interfaces Tail-Drop-Threshold - NETGEAR ProSafe FSM7328S User Manual
Layer 3 managed switch software
Hide thumbs
Also See for ProSafe FSM7328S:
- Administration manual (124 pages) ,
- Hardware installation manual (40 pages) ,
- Operating instructions manual (24 pages)
Table of Contents
Advertisement
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Interface
The following information is repeated for each queue on the interface.
Queue IdQueue identification number
The following information is repeated for each drop precedence level defined for the preceding
Queue Id.
Drop Precedence Level
WRED Minimum Threshold
WRED Maximum Threshold
WRED Drop Probability Scale
show interfaces tail-drop-threshold
This command displays the tail drop threshold configuration for each supported drop precedence
level of each queue for the specified interface. The slot/port parameter is optional and is only valid
on platforms that support independent per-port class of service mappings. If specified, the class-
of-service tail drop configuration of the interface is displayed. If omitted, the most recent global
configuration settings are displayed.
Format
Mode
Interface
The following information is repeated for each queue on the interface.
11-48
This displays the slot/port of the interface. If displaying the glo-
bal configuration, this output line is replaced with a Global Con-
fig indication.
An interface supports n queues numbered 0 to (n-1).
The number n is platform dependent and corresponds to the num-
ber of supported queues (traffic classes).
The drop precedence level for this queue, from 1 to p. The spe-
cific p value is platform dependent.
The WRED minimum threshold value for this drop precedence
level, expressed in sixteenths of the overall device queue size
(e.g., 0/16, 1/16, 2/16..., 16/16). This is a configured value.
The WRED maximum threshold value for this drop precedence
level, expressed in sixteenths of the overall device queue size
(e.g., 0/16, 1/16, 2/16..., 16/16). This is a configured value.
The WRED drop probability scale factor expressed as an integer.
This value, S, specifies that one out of every (2**S) packets are
dropped by WRED when the average queue length reaches its
maximum threshold value. This is a configured value.
show interfaces tail-drop-threshold [slot/port
Privileged EXEC
This displays the slot/port of the interface. If displaying the glo-
bal configuration, this output line is replaced with a Global Con-
fig indication.
202-10088-01, March 2005
Quality of Service (QoS) Commands
]
Advertisement
Table of Contents
