Show Diffserv Service Brief; Show Policy-Map Interface - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Policy Details

show diffserv service brief

This command displays all interfaces in the system to which a DiffServ policy has been attached.
The direction parameter is optional; if specified, only services in the indicated direction are shown,
otherwise service information is shown for both directions, where applicable.
Format
Mode
DiffServ Mode
The following information is repeated for interface and direction (only those
interfaces configured with an attached policy are shown):
Interface
Direction
OperStatus
Policy Name

show policy-map interface

This command displays policy-oriented statistics information for the specified interface and
direction. The <slot/port
parameter indicates the interface direction of interest.
Note: This command is only allowed while the DiffServ administrative mode is enabled.
Format
Interface
Direction
Operational Status
Quality of Service (QoS) Commands
Attached policy details, whose content is identical to that
described for the show policy-map <policymapname> command
(content not repeated here for brevity).
show diffserv service brief [in | out]
Privileged EXEC
The current setting of the DiffServ administrative mode. An
attached policy is only active on an interface while DiffServ is in
an enabled mode.
Valid slot and port number separated by forward slashes.
The traffic direction of this interface service, either in or out
The current operational status of this DiffServ service interface.
The name of the policy attached to the interface in the indicated
direction.
parameter specifies a valid interface for the system. The direction
>
show policy-map interface
Valid slot and port number separated by forward slashes.
The traffic direction of this interface service, either in or out.
The current operational status of this DiffServ service interface.
202-10088-01, March 2005
<
slot/port> <in | out>
11-37