Rinnai RH-KT2959-GBV Operation & Installation Manual page 9

To set up clean and fresh function after cooking, set the fan increase/decrease symbol to
0 on the display window. Turn OFF the LED light panel by touching and holding the light
symbol for approximately 1 second. Touch and hold the timer symbol for approximately 3
seconds. An audible signal will sound as an acknowledgement. When the signal tone is
activated, the function will start and after approximately 40 seconds all lights will be turn
off except for the ON/OFF symbol orange ring backlight and the timer symbol orange ring
flashing. To disable this function before the preset time expires, touch the ON/OFF
symbol, all symbols will light up. Touch the timer symbol for approximately 3 seconds to
disable this function.
Another alternative to operate this clean and fresh function if there is a need to clean the
air in the room when there is no cooking is to switch ON the extractor hood by touching on
the ON/OFF symbol. Touch and hold the timer symbol for approximately 3 seconds. An
audible signal will sound as an acknowledgement. When the signal tone is activated, the
function will start and after approximately 40 seconds all lights will be turn off except for
the ON/OFF symbol orange ring backlight and the timer symbol orange ring flashing. To
disable this function before the preset time expires, touch the ON/OFF symbol, all
symbols will light up. Touch the timer symbol for approximately 3 seconds to disable this
function.
Note: Clean and fresh function is preset to work for 5 minutes each hour for 24 hours at
fan setting speed 1.
If the extractor hood has been operated for 90 hours a white backlight dot will start
flashing on the lower right side of your display window. This is to remind you that the
metal grease filter should now be clean if you have not done so.
Note: To reset this function hold the timer symbol for approximately 5 seconds
If your extractor hood has been operated for 270 hours a white dot saturation indicator will
light up solidly on the lower right side of your display window to remind you that it is time
to change the charcoal/carbon filter if you have not done so. If heavy cooking is observed
or when the charcoal filters is/are noticeably dirty or discoloured, have the charcoal filters
replaced immediately. The charcoal filters are not washable and cannot be restored.
To reset this function touch and hold the timer symbol for approximately 5 seconds.
Note: The saturation indicator for charcoal/carbon filter does not apply to this
model
9