Main Board-2 - Sony PS-LX310BT Service Manual

PS-LX310BT
2-5.

MAIN BOARD-2

• Continued on 2-6 (page 17).
stand, etc.
front side
1 Remove the BT board cable (3P) (CN904).
(See Fig. C)
2 Remove the BT board cable (5P) (CN903).
(See Fig. C)
BT board cable (3P) BT board cable (5P) groove
CN903
CN904
front
side
–
BT board
16
Install the phono cable as shown figure below.
phono cable
groove
bottom side
three ribs
rear
side BT board cable (3P)
Note: Fix the BT board cable with using
–
rear side
groove
MAIN
board
groove
front side
rear side
5 motor assy cable
4 Peel off the bond fixing the BT board
cable (5P), and draw the BT board
cable (5P) out of the rib.
(See Fig. C)
3 Peel off the bond fixing the BT board
stand, etc.
cable (3P), and draw the BT board
cable (3P) out of the rib.
(See Fig. C)
BT board cable (5P)
bond bond
the bond of commercial products.
Sony CONFIDENTIAL
For Authorized Servicer
7 Remove the phono cable
from the groove.
8 five screws
(P2.6 8)
6 switch cable
connector (CN003)
connector (CN001)
SYS SET