Motor Assy - Sony PS-LX310BT Service Manual

PS-LX310BT
2-3.

MOTOR ASSY

1 Peel off the bond fixing the motor wire,
remove the four solders.
front side
2 two screws
(STEP F3
rear side
left side
14
bottom side
stand, etc.
Turn over.
top side
6.5)
Note 1: When the motor assy is replaced, make sure to refer to "SEC-
TION 3. ELECTRICAL ADJUSTMENT" on page 25 and per-
form the speed adjustment.
• Motor wire setting
Note 2: Fix the motor wire with using the bond of
commercial products.
bond
left side
[red]
[black]
motor wire connection
connector (CN004)
SPEED board
3 motor assy
Note 3: If you remove the two screws (step 2), the motor
assy will fall.
When removing the screws, make sure to remove
the screws while holding the motor assy so that
it does not fall.
Sony CONFIDENTIAL
For Authorized Servicer
motor assy
[white: 1 pin]
[white: 2 pin]
[white: 1 pin] [white: 2 pin]
rear side
front side
rear side
front side
SYS SET