Service Note; Disc Removal Procedure (At Power Off); How To Service Mb-108 Board - Sony XD-AX10 Service Manual

1. DISC REMOVAL PROCEDURE (at POWER OFF)

1) Open dust cover to access to a hole insert a tapering driver into the aperture of the unit bottom, and move the lever of chuck cam in the
direction of arrow A. (See Fig. 1)
2) Draw out the tray in the direction of arrow B, and remove a disc. (See Fig. 1)
The lever of chuck cam
B
Tray

2. HOW TO SERVICE MB-108 BOARD

• Jig
CK-121 board
(J-6090-128-A)
CK-122 board
(J-6090-129-A)
CK-120 board
(J-6090-127-A)
Flexible flat cables
FFC 26P J-6090-117-A
FFC 9P J-6090-118-A
FFC 5P J-6090-119-A
FFC 15P J-6090-121-A
FFC 25P J-6090-122-A

SERVICE NOTE

Hole
A
Stand
(J-6090-132-A)
Harness 6P
(J-6090-126-A)
Fig. 2
Dust cover
Fig. 1
1) Remove the upper case from the set. (Refer to section 2-2)
2) Remove the MB-108 board. (Refer to section 2-8)
3) Set the MB-108 board and CK-122 board to the stand as shown
in Fig. 3.
Connector
(CN601)
Two screws
(B3)
Connector
(CN101)
– 5 –
CK-122 board
MB-108 board
Stand
Fig. 3