Sony PS-LX310BT Service Manual page 6

PS-LX310BT
6. Press the [STOP] button on this unit to stop the playback.
Then press the [ PAIRING] button, check that [
ING] indicator lights off.
STOP
7. Press and hold down the [
about 10 seconds, delete the device information and complete
the checking work.
Tip
• Once you have paired your turntable and device,
you can connect to the paired device simply by
giving a short press to the BLUETOOTH button/
PAIRING button to enable your turntable's
BLUETOOTH function. You can also connect to
the paired device and play vinyl records by
pressing the START button on the front of the
turntable when the BLUETOOTH indicator is lit
orange (in standby).
• Press the BLUETOOTH button/
button to disengage from the BLUETOOTH
connection. The BLUETOOTH indicator turns off.
• You can register information for a maximum of
8 devices paired to your turntable.
You can delete all information for paired devices
by pressing and holding the BLUETOOTH
button/ PAIRING button for about 10 seconds,
and then releasing it.
If you cannot register (pair) devices
• If there are playback devices, which
support BLUETOOTH wireless technology
nearby, that have the BLUETOOTH
function enabled, but some of them are
not the device with which you want to
pair, disable their BLUETOOTH function
and try pairing again.
• With the pairing operation, the device
with which you do not want to pair may
be turned on and connected to the
turntable automatically. If this occurs,
change the device's setting not to turn on
by the BLUETOOTH connection, turn off
the device, and try pairing again.
• You cannot pair your turntable with
smartphones, TVs, or computers. The
turntable can use the BLUETOOTH
function to send data to playback devices
that support BLUETOOTH wireless
technology; however, because the
turntable cannot receive data from
smartphones, TVs, or computers, the
turntable cannot pair with them.
6
PAIR-
PAIRING] button on this unit
PAIRING
CHECK OF STORAGE HOLE FOR THE 45 RPM ADAPTOR
There is storage hole for the 45 rpm adaptor on the right side of this
unit.
Since customer might be storing the 45 RPM adaptor in this storage
hole, check whether there is the 45 RPM adaptor before working,
and be careful of falling, loss, damage etc.
REPAIRING OF EACH BOARD
When boards installed in this unit are defective, in all cases, boards
will be replaced.
The electrical parts mounted on the each board cannot be replaced
for repairing.
When the each board is defective, replace the individual board with
complete mounted board.
Sony CONFIDENTIAL
For Authorized Servicer
Storage hole
for the 45
rpm adaptor
SYS SET