Advertisement
Acijustments
PULLDOWN CLAW
APERTURE PLATE
o ')
STEP
end of PULLDOWN CLAW
FIGURE 7
To check:
Make 'a mark on the CLAW PROTRUSION GAUGE
TL-1007 9.5 mm (3/8") from the top. Hold the tool on
the APERTURE PLATE and align the mark with the
top of the PLATE.
THREADING KNOB
0
When you rotate the THREADING KNOB counter-
clockwise, the end of the PULLDOWN CLAW
touches the front of the step. If it does not touch the
front of the STEP, see step 3 to adjust.
To adjust:
Increase or decrease the number of CLAW SHIM
WASHERS, as necessary.
L,:e a 0.127 mm (0.005") WASHER-092950 and/or a
0,254 mm (0.010") WASHER-048968.
SMP 2 OA
Al
Advertisement
