Hearth Mount Installation - Regency Greenfire GF55-2 Specification Sheet

Table of Contents

Advertisement

Flexible or
Rigid 6" Stainless
Steel Liner
Flue
Connector
Clean-out tee
Masonry Fireplace
Freestanding Hearth Mount Installation
Freestanding Hearth Mount Installation
Steel Plate or Flashing

HEARTH MOUNT INSTALLATION

Damper Removed
or Fastened Open
10" (25.4 cm) Mantel
Minimum 8" (20 cm)
from top of stove
Combustible Floor
Rain cap
Storm collar
Seal plate (cover plate)
Existing masonry flue
Vent pipe (single wall
stainless flex pipe or
solid PL vent)
Flexible vent connector
(use this 5 foot [152cm]
section of pipe to vent
past fireplace damper or
small shelf)
Fireplace damper
location
Clean out tee
Existing fireplace
Overview
Refer to Figures on the left:
1. Install the hearth pad.
2. Lock the fireplace damper in the open position.
3. Install a positive flue connector at the fireplace
dampers or seal the chimney at the top.
4. Connect a tee to the exhaust pipe.
5. Install flexible stainless steel liner or listed pellet vent
to the top of the chimney.
Min 6" (15cm)
Hearth pad or
other floor
protection
GF55-2 Pellet Stove |
7

Advertisement

Table of Contents
loading

Table of Contents