Advertisement
HEARTH MOUNT INSTALLATION
Clean-out tee
Fresh-air intake should com
from chimney. If holes
already exist fresh-air intake
can be taken through back
of the fireplace or through
the ash dump.
1. Lock fireplace damper in the open position.
2. Install flexible stainless steel liner or listed pellet
vent to the top of the chimney. All joints in the
exhaust venting system must be fastened with
at least three (3) screws.
3. Install a sealing plate at the top of the chimney.
4. Connect a rain cap and flex adapter to the
chimney liner/pipe.
5. Connect a clean-out tee or a 90° elbow to the
liner/pipe.
6. Install tee onto stove.
6
| GC60-2 Pellet Stove
Masonry Fireplace
Hearth Mount - Side View
Damper Removed
or Fastened Open
Mantel
Minimum (8") 200mm
from top of stove
Min (6")
150mm
Floor
Protection
Combustible Floor
Hearth Mount - Over View
Rain Cap
Seal Plate
Existing Masonary
Flue
Vent Pipe (single wall
stainless flex pipe or
PL vent)
Flexible Vent Connector
(Use this 5 ft section of
pipe to vent past fireplace
damper or smoke shelf)
Fireplace Damper
Location
Clean Out Tee
Existing Fireplace
Advertisement
