Table of Contents
Advertisement
4
ASSEMBLY
HANDLEBAR INSTALLATION
11
Step 6:
Untie the wire tie in the upright and do not remove. Attach the end of the wire tie coming out of
the hole for the handlebar to the pulse grip wire coming out of the handlebar bracket as show in
Figure #11.
13
PAGE 10
Wire Tie
Wire Tie
12
Step 7:
Then holding one handlebar in your hand,
carefully pull the pulse sensor wire into
the upright with the wire tie and out of the
hole at the top of the upright Figure #12
above.
Once the wire is out of the top of the
upright, match the handlebar bracket
to the upright and slide one long bolt
in through the front of the upright to
temporarily hold the handlebar in place.
Do not tighten.
Install two Allen Head Bolts on the sides
bolt holes and secure tightly. Then tighten
the long bolt. Repeat for the opposite side
Figure #13.
Advertisement
Table of Contents
