Table of Contents
Advertisement
5
UNPACKING & LEVELER INSTALATION
REMOVE HELIX FROM WOODEN BASE.
18
19
Step 11:
Tilt the machine back and remove two bolts holding the Helix to the wooden base. Then place
machine back level. Next remove the zip ties holding the rear of the Helix to the wooden base.
Figure #18
INSTALL LEVELER FEET
Step 12:
Once again tilt the Helix on the rear transport wheels to allow installation of the leveler feet
into the threaded holes in the front and rear of the stabilizer tubes Figure #19.
PAGE 13
Advertisement
Table of Contents
