Reference
Plastic parts employ not only ABS (Acrylonitrile
Butadiene Styrene) plastic but also polypropylene, vinyl,
or the like plastic. Burning test method to identify ABS
plastic is described below.
1) Use a sharp blade to cut off a plastic sliver from the
part at its hidden backside.
Sealant Application Areas
Front Structure Panel
"A": Flatten sealant.
2) Hold sliver with pincers and set it on fire.
3) Carefully observe condition of the burning plastic.
4) ABS plastic must raise readily distinguishable back
smoke while burning with its residue suspended in
air temporarily.
5) Polypropylene must raise no readily distinguishable
smoke while burning.
Component Location
"B": Smooth out sealant with a brush.
Paint / Coatings:
9L-2
S6JB0A9C03001
I5JB0A9C0001-03