Multitech RouteFinder RF560VPN Reference Manual page 13

Site B Configuration
Follow the same basic procedures as used for Site A.
Note that some parameters are different for Site B.
For detail related to each step, see Site A procedures.
Step 1 – Connect a workstation to the RF660VPN's LAN port via Ethernet for Site B.
Step 2 – Use the same IP Address as used for Site A (Set the workstation IP address to 192.168.10.1 subnet).
Step 3 – Turn on the power.
Step 4 – Bring up your Web browser on the workstation. At the Web browser address line, type the default
Gateway address:
Step 5 – Follow the Site A User Name and Password login instructions.
Step 6 – If someone else is already logged in to the RouteFinder, or if you were logged in recently, a message
will ask you: Do you want to log the user out?
Click the Yes Button.
The Login screen displays. Repeat step 5.
Step 7 – The Web Management Home screen displays.
Step 8 – Click on Administration > System Setup to set the correct zone, date, and time for your location.
Step 9 – Click on Wizard Setup. Enter information for Site B of this example.
a) Enter the Administrator Email Address (can be anything). (Example: admin@yourdomain.com)
b) Enter the Host name for the RouteFinder (can be anything). (Example: RF660VPN.Site-B.com)
c) LAN IP Address and Subnet Mask are set at the defaults. This should be acceptable for Site A.
d) Enter the WAN IP Address. This is the PUBLIC STATIC IP address. (Example: 204.26.122.3)
e) Change the Gateway IP address; this is the IP address of the router that connects to the Internet.
(Example: 204.26.122.1)
f) Place a checkmark in the Packet Filter Rule: LAN-ANY-ANY-ALLOW box. This enables the rule.
g) Specify any changes to the passwords that you feel are necessary.
h) Click Save to save the settings you just entered.
i) A screen displays prompting you to save your changes. Click OK.
j) Another screen displays to tell you not to close your browser while the settings are being saved.
Step 10 – Click on Networks & Services > Network.
Define the IP network configured on the remote LAN port (the private LAN on eth0 at Site B) by
entering the following information.
For example
Name = RemoteLAN
IP address = 192.168.2.0
Subnet mask = 255.255.255.0
Define the IP address that is configured on the remote WAN port (the public WAN on eth1 at
Site B) by entering the following information.
For example
Name = RemoteWAN_IP
IP address = 204.26.122.103
Subnet mask = 255.255.255.255
Step 11 – Click on Packet Filters > Packet Filter Rules. The rule for LAN is already defined. Add the rule
RemoteLAN – Any – Any – ACCEPT. This allows the Remote LAN at Site B to access the
RouteFinder and LAN at Site A.
Step 12 – Click on VPN > IPSec.
Use the same settings as used for Site A, and add a manual connection using the same settings
as used for Site A.
This completes the configuration of the RF660VPN at Site B for Example 1.
Multi-Tech Systems, Inc. RF760/660/600VPN Tunnel Examples Reference Guide (S000308D)
Example 1 Site B Configuration
https://192.168.10.1 and press Enter.
Example 1 – Site B
13