Table of Contents
Advertisement
MultiFRAD 100-Series User Guide
Installing Your MultiFRAD Software
The following loading procedure does not provide every screen or option in the process of installing
the MultiFRAD software. The assumption is that a technical person is doing the installation and that
a thorough knowledge of Windows and the software loading process is understood. Additional
information on the MultiFRAD software is provided in Chapter 4 of this User Guide.
1. Run Windows on the PC connected to the Command Port.
2. Insert the MultiFRAD software disk into the PC disk drive.
3. Win98/95/NT users - click Start I Run. In the Run dialog box click the down arrow and choose
a:\setup or b:\setup (depending on the location of your floppy disk drive) or use the Browse
button and click on Setup, then click OK.
Win3.1 users - in the Program Manager, access Run by clicking File I Run. In the Run dialog
box, type a:\setup or b:\setup (depending on the location of your floppy disk drive) in the
Command Line field and then click OK.
4. Windows prepares the install shield and then the Welcome dialog box welcoming you to the
MF100 Setup program screen is displayed.
Click Next > to continue.
5. The Choose Destination Location dialog box is displayed.
Follow the on-screen instructions to install your MultiFRAD software. You may choose the
Destination Location of your MultiFRAD software or you can choose to select the default
destination by clicking Next >.
Note: If you click on the Browse button you can choose from several folders. Multi-Tech
Systems recommends that you choose the default destination.
20
FR111A
Advertisement
Table of Contents
