Table of Contents
Advertisement
MultiFRAD 100-Series User Guide
Introduction
This chapter is organized in the way you will unpack and cable your MultiFRAD. The unpacking
section describes the contents of the shipping box and shows how the MultiFRAD is packaged. The
installation procedure describes each cable connection and shows where that cable is connected to
the MultiFRAD. If the shunt on the data port needs to be moved to its V.35 position, this can not be
done until after the MultiFRAD is configured.
Unpacking Your MultiFRAD
The shipping box contains the MultiFRAD, external power supply, trunk RJ-48 phone cord, your
Quick Start Guide, and two diskettes (i.e., the MultiFRAD 100-Series User Guide, and the MultiFRAD
Software). Inspect the contents for signs of any shipping damage. If damage is observed, do not
power up the unit; contact Multi-Tech's Technical Support for advice (refer to Chapter 5). If no
damage is observed, place the MultiFRAD in its final location and refer to Cabling your MultiFRAD in
the next section.
Safety Warning Telecom
1.
Never install telephone wiring during a lightning storm.
2.
Never install a telephone jack in wet locations unless the jack is specifically designed for wet
locations.
3.
This product is to be used with UL and cUL listed computers.
4.
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
5.
Use caution when installing or modifying telephone lines.
6.
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a
remote risk of electrical shock from lightning.
7.
Do not use a telephone in the vicinity of a gas leak.
8.
To reduce the risk of fire, use only 26 AWG or larger telecommunication line cord.
14
U.S .A
M AD
E IN
MA DE IN
U. S. A
Figure 2-1. Unpacking
FR111A
Advertisement
Table of Contents
