Table of Contents
Advertisement
Chapter 3 – Installing and Using the eCell
Installing the SIM Card
This device requires a SIM card, which is supplied by your service provider. Install the SIM card before connecting
antennas and cabling the device.
To install the SIM card:
1.
Locate the SIM card slot on the side of the device. The slot is labeled SIM.
2.
Slide the SIM card into the SIM card slot with the contact side facing down as shown. When the SIM card
is installed, it locks into place.
Attaching Antennas and Cables
Note:
Before powering up the device, enable DHCP on your computer's Ethernet port.
1.
Connect the provided antennas to the connectors labeled CELL and AUX. Finger tighten. For best cellular
performance, position the top of the antennas as far apart as possible.
2.
Connect the Ethernet cable between the Ethernet ports on your computer and the device.
3.
Connect the power adapter to the 12V DC connector.
4.
To power up the device, plug the power adapter into an electrical outlet.
®
MultiConnect
eCell User Guide
INSTALLING AND USING THE ECELL
9
Advertisement
Table of Contents
