Garmin G1000 System Maintenance Manual page 14

If the technician is unsure of an aircraft's STC configuration, perform the
following:
After acknowledgement of the splash screen, use the FMS knob on the GCU 477 controller to go to the
AUX – SYSTEM STATUS page on the MFD. In the AIRFRAME section (upper right corner,) the
display shows the current G1000 airframe configuration and system software version number. The
airframe configuration is shown in the AIRFRAME field and the system software version number is
shown in the following format: 'SYS SOFTWARE VERSION XXXX.XX'. It correlates to the software
image used to load the software to the system:
EXAMPLE:
System Software Version
With the PFD in configuration mode (see section 3.7), go to the GDU-AIRFRAME CONFIGURATION
page. In the AIRFRAME section (upper right corner), verify the correct configuration for SERIES,
ENGINE and PROP.
EXAMPLE:
For a configuration that loaded "King Air B300 PT6A-60A", the AIRFRAME section should display:
SERIES: B300
ENGINE: PT6A-60A
PROP: HARTZELL 4
Page 1-2
Revision 4
IMPORTANT!
'0985.04'
= Software Image P/N 006-B
G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
0985-04
190-00716-01