HP Enterprise ProLiant DL380 Gen10 Maintenance And Service Manual page 139

Replacing the Pensando DSP DSC-25 2p SFP28 card Replacing the Pensando DSP DSC-25 2p SFP28 card with the
Pensando DSP iLO Sideband ALOM Module requires that the accompanying Smart I/O card (such as the Pensando DSP DSC-25 2p
SFP28 card) be installed on slot 3 of the primary PCIe riser cage.
Prerequisites Prerequisites
Before installing this option, be sure you have the following:
The components included with the hardware option kit.
T-10 Torx screwdriver.
Procedure Procedure
1. Install the Pensando DSP iLO Sideband ALOM Module into the FlexibleLOM adapter connector on the system board.
2. Remove the shipping cap from the auxiliary cable.
3. Connect the auxiliary cable to the iLO Sideband ALOM Module:
a. Align the connector keying posts to the ALOM module.
b. Secure the auxiliary cable to the ALOM module using the thumbscrew.
CAUTION: CAUTION:
Do not over torque the screw.
CAUTION: CAUTION:
Do not use a screwdriver to tighten the screw.
CAUTION: CAUTION:
Do not twist the cable service loop during installation.
4. Install the DSC-25 card into the PCIe slot.
Replacing the Pensando DSP DSC-25 2p SFP28 card with the iLO Sideband ALOM Module
with the iLO Sideband ALOM Module iLO Sideband ALOM Module
139