Preparation - Toto NEOREST TCF996RWG/RWSW Instruction Manual

Preparation

1.Insert the battery
1 Remove the remote control
from the hanger.
Remote control
Hanger
Open the battery cover and
2
insert two AA batteries.
Close
Open
Battery cover
●When batteries are properly inserted,
temperature levels appear on the display of
the remote control (back side).
●The display goes out when no button on the
remote control is pressed for 1 minute or
more.
WATER TEMP
SEAT TEMP
DRYER TEMP
3 Mount the remote control in
the hanger.
■ About the batteries
• Use dry cell, alkaline batteries.
• Be sure to follow "Safety Precautions" to prevent
the batteries from rupturing or leaking fl uid.
(Pages 8, 10)
14
Using the Product for the First Time
If the remote control is secured
(for anti theft)
Remove the screws (2, left
1
and right) from the remote
control fi xture.
View from side
Remote
control
Wall
Phillips
screwdriver
(Fine-tip type)
Remove
2 Remove the remote control
from the hanger.
Remote
control
Wall
■ To secure the remote control again
Tighten and fi x the screws (2, left and right).
(Overtightening may cause damage to parts
such as the hanger)
1
Remove the side-panel and
insert the power plug.
Switch the breaker on the
distribution board to ON.
• The wand extends and then retracts.
• Flushes automatically.
Hanger
Screw
(2 pieces,
left and right)
2
Check that the POWER LED
on the main display is lit up.
• If it does not light up, press [POWER
ON/OFF] to light it up.
3
Reinstall the side-panel.
Reference line for
panel installation
Hanger
To turn the power "OFF"
Press [POWER ON/OFF] to
turn the power off.
• The POWER LED goes off.
2.Turn on the power
Loosen the bottom screw of the side-panel (right) with a
flat-head screwdriver, pull the side-panel diagonally upward,
and then pull it out downward.
(UK)
Side-panel (right)
Screw
(1) Loosen
• Both side-panels can be removed or installed in the
same way.
• Dropping the side-panels may cause damage.
(Europe and Russia)
Keep the side-panel (right) aligned with the reference line for panel
installation, and then tighten the bottom screw with a flat-head screwdriver.
(1) Fit it in from (2) Keep it aligned with
below at an the reference line for
angle. panel installation
(1)
(2)
(3) Tighten
(3)
3.Open the shutoff valve
1 Fully open the shutoff valve.
The shutoff valve is located in the side-panel (left).
(Refer to the above for removal and installation.)
(2)
Pull up
(3)
Pull out
Side-panel (left)
15