Preparation; Using The Product For The First Time - Toto NEOREST AS Instruction Manual

Introduction

Preparation

Using the Product for
the First Time
1.
Insert the battery
1.1
Remove the remote control from the hanger.
Remote control
Hanger
1.2
Open the battery cover and insert two AA batteries.
Insert batteries and close the battery cover.
Remote control backside
⊖ ⊖
⊕ ⊕
Close Close
Open Open
⊕ ⊕
⊖ ⊖
Battery cover
 When batteries are properly inserted, tem-
perature levels appear on the display of
the remote control (back side).
When the temperature levels are not displayed.
Perform step 3 of "Language settings".
(  Page 42)
The display goes out when no button on the
remote control is pressed for about
60 seconds or more.
WATER TEMP
SEAT TEMP
DRYER TEMP
1.3
Mount the remote control in the hanger.
About the batteries
Use dry cell, alkaline batteries.
Be sure to follow "Safety Precautions" to prevent the
batteries from rupturing or leaking fl uid. (  Pages 4, 7)
14
If the remote control is secured to prevent theft
1) Remove the screw from the remote control fi xture.
(2 pieces, left and right)
View from side
Remote control
Hanger
Wall
Phillips screwdriver
Screw
(Fine-tip type)
(2 pieces,
Remove
left and right)
2) Remove the remote control from the hanger.
Remote control
Hanger
Wall
To secure the remote control again
Tighten two screws on the left and right to secure it.
Overtightening may cause damage to parts such as the
hanger.
2.
Turn on the power
2.1
Insert the power plug.
 The wand extends and then retracts.
2.2
Check the "Power" LED illuminates.
If the light is off
Switch "Power" to "ON" using the remote control.
To operate from the back of remote control
1)
Press "Power ON/OFF" button about 3 seconds or
longer.
To operate from the front of remote control
Recommended if the remote control is secured to
prevent theft, etc.
1) and
Press the "Stop" button and "Water pressure
adjustment +" button at the same time for about
10 seconds or longer.
To turn the power "OFF"
Unplug the power plug.
 The "Power" LED is unilluminated.
Introduction
3.
Open the shutoff valve
3.1
Remove the access cover (left).
3.2
Fully open the shutoff valve.
Handle
(For opening or closing
the shutoff valve)
Shutoff
valve
Note: The handle is provided on the back side of the left
access cover.
3.3
Attach the left access cover.
 Attach the left access cover so that there are
no gaps between it and the bowl unit top /
sides.
Top of the bowl unit
Left access cover Side of the bowl unit
15