Commissioning Via Lui; Introduction; Overview - Siemens SITRANS F Operating Instructions Manual

Commissioning

6.3 Commissioning via LUI

6.3 Commissioning via LUI
6.3.1

Introduction

In this chapter it is described how to commission the device via the local user interface (LUI)
using the Quick Start menu.
For further information on how to operate the device via LUI, refer to "Operating; Local User
Interface (LUI)" (Page 91).
Recommendation
Before commissioning a basic knowledge of the local display and the menu structure should
be obtained. This is offered in the chapters
● "Local user interface (LUI)" (Page 91)
● "Navigating the menu" (Page 92)
Quick Start menu
The LUI includes a Quick Start menu with the most important parameters/menus for quick
configuration of the flowmeter.
6.3.2

Overview

Quick start steps
The quick start menu prompts for check or setup of the following parameters/menus:
● Flow Direction
● Process Noise Damping
● Massflow
● Volumeflow
● Density
● Fluid Temperature
● Fraction
● Totalizer 1
● Totalizer 2
● Totalizer 3
● Start Zero Point Adjustment
Before a zero point adjustment is initiated, the pipe must be filled at an absolute flowrate of
zero.
70
SITRANS FC430 with HART
Operating Instructions, 03/2012, A5E03361511-01