Table of Contents
Advertisement
Confirmation Mode (USB connection only)
Use this mode to specify processing conditions from the application.
This mode stops the process that starts with cut sheet feeding is from the ASF and ends with cut sheet output to
a pocket, in order to receive an instruction from the application. It then restarts the process. It also can be used
to configure the no-overlap/overlap setting from the application.
No-overlap: Starts send of the next cut sheet after the current cut sheet is fully in the pocket
Overlap: Starts feeding of the next cut sheet while the current cut sheet is being output to the
pocket
Document Processing Sequence
The processing sequence changes depending on whether there is overlap operation or not.
With overlap
<First cut sheet>
Fed from the ASF
Check for double feeding
MICR reading
Ink jet printing
Capturing image on both sides
Stop of paper feeding*
Ejection of the cut sheet
∗ Waits for a command from the
application.
<Second cut sheet>
Fed from the ASF
Check for double feeding
Stop of paper feeding*
Ejection of the cut sheet
Chapter 1 Product Overview
<Third cut sheet>
Fed from the ASF
28
Advertisement
Table of Contents
