Connecting To A Host; Connecting To An Ethernet Lan - Epson TM-S9000II-NW Technical Reference Manual

Connecting to a Host

Connecting to an Ethernet LAN

1
Put the product in network mode using the interface selection switch on the rear.
2
Connect a LAN cable to your router or hub.
3
Turn on the product.
4
Press Button 1 and Button 2 at the same time for two seconds to display and check
the network settings of the product.
5
Start a browser on the host device and enter the IP address of the product to open
Web Config.
6
Modify the product's network settings in Web Config.
7
Restart the product.
Network
The product is in the network mode by default.
Ethernet
Chapter 2 Setup
42