Advertisement
2.1 Installation Procedure
1. Jumper settings
2. Installation of CPU
3. Installation of Memory
4. I/O Connections & Panel Connections
2.1.1 Jumper Settings
In this manual , (1-2) represents the first and second pins of the jumper. (2-3) represents the second
and third pins of the jumper. On the motherboard, you will see two sets of jumpers with different
color jumper caps:
Yellow Jumper Caps :
Green Jumper Caps :
Red Jumper Caps :
WARNING: Electronic parts are Static sensitive. To prevent damage to the computer and its parts
please take the following measures.
-Work on a surface such as concrete, linoleum or hard wood floor.
-Ground your self with either a properly installed grounding strap or by touching a major electrical
appliance long enough to discharge the static.
2.1.2 Enable/Disable Sound (JSND : Red Jumper Cap) (The Sound function and jumper are optional)
This jumper lets you to enable or disable the sound function.
1-2 : Enable Sound function (Default Setting)
2-3 : Disable Sound function
2.1.3 Clearing the CMOS (Yellow Jumper Caps)
JRTC: CMOS Function Selection
1-2 : Clear data
2-3 : Normal Operation (Default Setting)
How to Clear the CMOS Setting
1.
Turn off the power.
2.
Remove ATX power cable from connector J1.
3.
Remove Yellow Jumper Cap from JRTC (2-3) and put on JRTC (1-2) to remove the CMOS setting.
4.
Remove Yellow Jumper Cap from JRTC (1-2) and put on JRTC (2-3).
5.
Connect ATX power cable back to connector J1.
Sets the Function of Flash CMOS
JRTC
Sets the type and speed of CPU
JF0, JF1, JF2, JF3
Sets the FSB frequency of CPU JFSB
Enable/Disable Sound function JSND (optional)
Advertisement
