Advertisement
This allows you to remotely power up your system through your network by sending a wake-up frame or
signal. With this feature, you can remotely upload/download data to/from systems during off-peak hours.
Set to Enabled to set this feature.
3.5.15 Date (of Month) Alarm, Time (hh:mm:ss) Alarm
Set these options to specify the RTC Alarm time on Date / Hour / Minute / Second.
3.5.16 IRQ 8 Break Suspend
To enable or disable the detection of IRQ 8 (RTC) event for power down state transition.
3.5.17 IRQ[3-7, 9-15], NMI
To enable or disable the detection of IRQ 3-7, IRQ 9-15 or NMI interrupt events for power down state
transition.
3.5.18 Primary/Secondary IDE 0/1, Floppy Disk, Serial & Parallel Port
These items enable or disable the detection of IDE, floppy, serial and parallel port activities for power
down state transition. Actually it detects the read/write to/from I/O port.
3.6 PNP/PCI Configuration Setup
3.6.1 PNP OS Installed
This field allows you to use a Plug-and-Play (PnP) operating system.
Please set it as "No" if the operating system has no PnP function or to avoid reassigning the IRQs
by the operating system.
3.6.2 Resources Controlled By
Default setting is "Auto". This setting allows the BIOS to self detect setting and Plug-and-Play devices
during start up. The user can select and configure IRQs under "Manual" mode.
3.6.3 Reset Configuration Data
Figure 3.6 PNP/PCI CONFIGURATION SETUP
ROM PCI / ISA BIOS (XXXXXXXX)
PNP/PCI CONFIGURATION
AWARD SOFTWARE, INC.
Advertisement
