Advertisement
Max Saving
User Defined
3.5.3 PM Control by APM
Select "Yes" if your system has Advanced Power Management (APM).
3.5.4 Video Off Method
This field defines the video off features. The following options are available: DPMS OFF, DPMS Reduce
ON, Blank Screen, V/H SYNC+Blank, DPMS Standby, and DPMS Suspend. The DPMS (Display Power
Management System) features allow the BIOS to control the video display card if it supports the DPMS
feature.
3.5.5 Video Off After
This option allows your monitor to blank after your system went into Doze, Standby or Suspend mode.
You can elect to not blank screen by select "N/A" Default value is "Standby".
3.5.6 Doze Mode
When system is inactive after the predefined time limit, system performance will drop down. This is the
first level of Power Management.
3.5.7 Standby Mode
System turns off the video signal and the fixed drives. This is the second level of Power Management.
3.5.8 Suspend Mode
System further shuts down all devices except for CPU itself. This is the third level of Power Management.
3.5.9 HDD Power Down
This instructs hard drives to shut off while in the Power Management modes.
3.5.10 PCI/VGA Act-Monitor
To enable or disable the detection of VGA activity for power down state transition.
3.5.11 Soft-off by PWR-BTTN
When set to "Delay 4 Sec.", the ATX switch can be used as a normal system power-off button when
pressed for less than 4 seconds. "Instant" disables the ATX switch function when the button is pressed
under 4 seconds.
3.5.12 PowerOn by Ring
This option lets you specify enable or disable external Modem Wake Up function. The function of power on
through modem when system is off.
To select "Enabled" : To let the system to enter the environment of DOS or Windows 95/98 OS before
system is power off. As long as there are any massage through the Modem to enter the System during
system is power off. The system will enable power on function.
3.5.13 Resume by Alarm
Set this option to enable or disable the RTC Alarm to Wake Up the system which is set at soft Off.
3.5.14 Wake up on LAN
System starts power saving function when the inactivity period
exceeds 1 min.
Allows user to define the inactivity period before power saving
function activates,
Advertisement
