Advertisement
3.3.2 CPU Internal/External Cache
These options are to enable or disable CPU Internal (L1) Cache, or External (L2) Cache.
3.3.3 CPU L2 Cache ECC Checking
Select "Enabled" to enable CPU L2 Cache ECC Checking.
Select "Disabled" to disable CPU L2 Cache ECC Checking.
3.3.4 Quick Power On Self Test
Select "Enabled" to speed up time required to complete Power-On Self-Test.
3.3.5 Boot Sequence
This option allows user to assign boot sequence of the system. Available options are A, C, D, E, F, CD-
ROM, SCSI and LS120/ZIP.
3.3.6 Swap Floppy Drive
When enabled, physical drive A will be assigned to logical drive B, and physical drive B will be assigned to
logical drive A.
3.3.7 Boot Up Floppy Seek
The system will detect and verify operation of the floppy drive type .
3.3.8 Boot Up Numlock Status
The option allows the <NumLock> key to be activated after system boot up.
3.3.9 Typematic Rate Setting
Select "Enabled" to configure "Typematic Rate" and "Typematic Delay" functions.
3.3.10 Typematic Rate
Use this option to set the rate at which a character keeps repeating while you hold down a key.
3.3.11 Typematic Delay
Select "Enabled" to set the length of delay before key strokes to repeat. Available options are
"250","500","750", and "1000".
3.3.12 Security Option
You can select whether the password is required every time the system boots or only when you enter the
Setup. You can assign "Supervisor Password" and "User Password" in the main CMOS Setup Utility
Screen.
3.3.13 PCI/VGA Palette Snoop
Enable this option to correct screen color shifts, when there is a combination of VGA cards, accelerator
cards, or MPEG cards present.
3.6.14 Assign IRQ For VGA
The Enabled option allows the BIOS to auto-route an IRQ for use by a VGA card. While most of the VGA
cards do not need the IRQ assignment, certain VGA cards may need it.
3.3.15 OS Select for DRAM > 64MB
Advertisement
