Vent System; Glass Door; Stones - Vermont Castings VWDVP70NTSC Installation And Operating Instructions Manual

Direct vent gas fireplace
Table of Contents

Advertisement

CLEANING AND MAINTENANCE
If the fl ame is blue and candle-like in appearance, adjust
glass or add more glass over ports.
NOTE: The type of installation, vent system confi guration,
and wind effects may cause the fl ame patterns to vary.

VENT SYSTEM

The fi replace and venting system should be inspected
before initial use and at least annually by a qualifi ed fi eld
service person. Inspect the external vent cap on a regular
basis to make sure that no debris is interfering with the
airfl ow. Inspect entire venting system to ensure proper
function.

GLASS DOOR

Thoroughly clean the inside of the glass door after using
the fi replace for two hours. Periodically clean the glass
door as necessary.
When cleaning the glass, remember:
Do not remove the glass when hot. Allow glass to
cool before removal.
NEVER use abrasive materials.
Keep children and pets a safe distance away.
Never operate the fi replace without the glass door
properly secured.
Never operate the fi replace if the glass is broken.
Replace any glass that is chipped, cracked, or broken.
Replacement glass door assemblies MUST be supplied
by the fi replace manufacturer – No substitute materi-
als may be used.
Handle glass door with care to avoid striking or scratch-
ing it on hard objects.
To clean glass door, follow "Glass Removal" procedure
outlined in the Final Installation section. Film deposit on the
inside of the glass should be cleaned off using a nontoxic,
non-corrosive, non-abrasive, mild-cleaning solution. Simply
apply an adequate amount to the glass and wipe off with
a damp cloth. After all maintenance has been completed,
re-install glass door.

STONES

If stones must be removed for cleaning, handle carefully by
holding gently at each end. Gloves are recommended to
prevent skin irritation from ceramic fi bers. If skin becomes
irritated, wash gently with soap and water. Vacuum surface
of stones with brush attachment or brush logs with a soft
bristly (i.e. clean, dry paintbrush). To place stones in the
fi replace, refer to Stone Placement section on Page 30.
NOTE: Do not use fl uids to clean ceramic fi ber stones.
20306745
VWDV70 Series Gas Fireplace
49

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vwdv70ntscsb

Table of Contents