Table of Contents
Advertisement
VWDV70 Series Gas Fireplace
Due to the sensitive temperature monitoring
components in the transmitter, it is necessary
to allow the transmitter to stabilize to room
temperature before accurate room tempera-
tures are displayed. If the transmitter is acti-
vated from a severe cold condition, allow 15
minutes for accurate temperature readings to
appear on the LCD display.
Turn appliance OFF (at the Master Switch) if
you are away from your house for an extended
period of time. Never leave anything on top of
the surface of the transmitter.
Function Areas of the LCD Display
Figure 58 shows the display of the TSFSC LCD.
Information Bar
The information bar shows the room temperature, the
"sending signal" radio icon, the low battery indication icon,
the child-proof icon, and the fl ame icon. This area doesn't
have touch buttons.
•
The room temperature will always be shown after
power-up. It displays the room temperature from 40
°F to 99 °F. "Lo" and "HI" will be displayed when the
room temperature is lower than 40°F or higher than
99°F, respectively.
•
The radio icon will be shown when the transmitter is
sending a signal.
•
The low battery indication icon will be shown when
the battery voltage is low.
•
The child-proof icon will be shown when the child-
proof mode is activated.
•
The fl ame icon indicates the current fl ame height -
Off, Low, Medium and High
Touch Area
The touch area contains all touch buttons to control the
transmitter. It consists of two categories: menus and ad-
justment arrows. The blue LED backlight lights up for 8
seconds when any of the touch buttons is pressed.
•
The menus include TIMER, THERMO, LIGHT, FAN
and AUX.
•
The adjustment arrows include ON/up and OFF/
down. Their default function is to adjust the fl ame
height. When a button from the menu is pressed,
the ON/up and OFF/down buttons will temporarily
become adjustment controls for the selected item.
When the adjustment is done, the ON/up and OFF/
down buttons go back to fl ame height controller
again.
40
TOUCH SCREEN REMOTE CONTROL OPERATION
Function Areas of the LCD Display
Figure 60
Logo Bar
The Logo Bar contains the brand logo: Signature Com-
mand System.
Initialization and Setting up
Installing Batteries:
Figure 61
The remote transmitter has two battery compartments,
one on each end of the transmitter. Always change all
four (4) batteries at the same time.
To install batteries:
1. Press down the battery door tab
and pull out to remove the bat-
tery door.
2. Install the batteries as indicat-
ed inside the battery compart-
ments.
3. Close the battery door by snap-
ping in place.
4. When all four batteries are in-
stalled, the transmitter will ini-
tialize for 5 seconds and then is
ready for use.
5. The batteries should be re-
placed every 12 months or
when the low battery icon indicator is displayed.
Changing Temperature Unit
When batteries are installed in the transmitter,
1. All available icons on the LCD will be turned on then
be cleared.
2. The LCD will display temperature unit: °F. Use ON ∆
to toggle the units between °F and °C within the fi rst 5
seconds.
3. The transmitter enters Manual Mode
4. The LCD displays room temperature with the chosen
unit.
Battery
Door
Tabs
Figure 61
20306745
Advertisement
Table of Contents
