Samsung OfficeServ 7100 Technical Manual page 89

Hide thumbs Also See for OfficeServ 7100:
Table of Contents

Advertisement

OfficeServ 7100
TECHNICAL MANUAL
MMC: 840
DESCRIPTION:
This MMC provides a means to register the IP keyphones and softphone with the
OfficeServ 7100 system. During registration, the IP and MAC addresses are also
registered. The User ID and Password must match the table entry in this MMC for
the IP keyphone to be registered. System default numbers start at 3201~3224.
System default User ID's match the default station numbers. (3201~3224). The
system default password is 1234. IP keyphones must be individually programmed
with User ID and Password to register with the system.
NOTE: When changing any IP address/value, listed below, three digits must
be input for each (octet) field. Example 192.168.1.10 input must be: 192 168
001 010
USER ID:
OfficeServ 7100 system. This entry can be alphanumeric.
USER PSWD: This is the Password the IP keyphone must also have to register
with the OfficeServ 7100 system. This entry can be alphanumeric.
IP ADDR: This is the IP address of the IP once registered with the OfficeServ
7100 system. View only.
MAC ADDR: This is MAC address of the IP keyphone once registered with the
OfficeServ 7100 system. View only.
SIG PORT: Indicates the port number used for keyphone control signaling. This
information will be needed when traversing NAT routers, firewalls, etc. View only.
VOICE PORT: Indicates the port number used for transporting voice content.
This information will be needed when traversing NAT routers, firewalls, etc. View
only.
IP TYPE: This is the type of IP network used where the ITP is located: PRIVATE
or PUBLIC, or PUBLIC with FIREWALL. "PUBLIC with FIREWALL" option must
be selected when there are firewalls/NAT routers between system and remote
ITP's.
DSP TYPE: This selects which CODEC this keyphone's DSP will use. G.729A
(low bandwidth) or G.711 (high bandwidth). This applies to ITP to ITP
communication only. ITP to TDM follows MMC 835.
This is the ID the IP keyphone must match to register with the
PROGRAMMING
PART 2 APRIL 2007
IP SET INFO

Advertisement

Table of Contents
loading

Table of Contents