Table of Contents
Advertisement
Installing the Cellular Router
credentials of the Tracer SC+ controller must be entered in the Tracer 10" display configuration.
Testing the Cellular Router
After the Digi router has been connected to a power supply and the antennas are connected, test the
device and the wireless signal.
1. Log into the Tracer BAS user interface.
2. On the left navigation menu, select Installation>Identification and Communications.
3. Select the Trane Intelligent Services Configuration tab.
4. Click Test Connection to test the wireless connection.
14
Note: If you need additional information on configuring the Tracer BAS controller, refer to the
appropriate Installation & Setup guide.
Figure 3. Tracer SC+ navigation to Identification and Communications page
BAS-SVX067H-EN
Advertisement
Table of Contents
