Vodavi STARPLUS Triad XTS Installation Manual page 65

CO/PBX Connections
Route
Found
ICLID
DID
NONE
T-1 Ordering Information: When ordering a T-1 circuit from a carrier, request either D4
framing and Alternate Mark Inversion (AMI) Line coding using the superframe (SF) or the
Extended Superframe (ESF-B8ZS) format. The following are additional ordering information
specifications:
Circuit Information
Supervisory Signaling
Address Signaling
Start Dial Indicator
* ANI/DNIS not available on Loop/Ground start signaling. If Loop Start signaling protocol is ordered,
the Central Office does not provide Disconnect Supervision. However if TIE signaling protocol is
ordered,
disconnect supervision is provided. The switching equipment processes DNIS numbers received from
the T-1 circuit depending on the trunk simulation.
Installing the DTRU4 Modules
1. Unpack the DTRU4 modules from their antistatic conductive bags.
2. Locate the CN1 and CN2 connectors on the DTRU4 modules.
3. Locate the CN4, CN5, CN8 and CN9 connectors on the T1IB.
Table 3-10: Call Routing Display Format
Type of
Display
ICLID ANI number placed in the 14-character number field, the
DNIS number followed by the name programmed in ICLID
translation table placed in the 24-character name field.
ICLID ANI number placed in 14-character number field. DNIS
number followed by programmed name from the DID
tables in 24-character name field.
ICLID ANI number placed in 14-character number field and the
DNIS number is placed in the 24-character name field.
Table 3-11: T-1 Ordering Specifications
If ordering...
Table 3-12: Telco to T1IB Interconnect Diagram - Pin Connections
Telco
RJ45
1-->
2-->
4-->
5-->
Format
ANI/DNIS/
DID/TIE Ground Start Signaling*
2 wire
TIE
DTMF
Wink Start
T1IB
DB15 Female Pin #
<--9
<--1
<-- 11
<--3
Chapter 3 - System Installation
Loop Start/
2 wire
Loop or Ground
DTMF
Dial Tone
3-31