Vodavi STARPLUS Triad XTS Installation Manual page 132

4-30
Chapter 4 - Maintenance and Troubleshooting
RV_MAKE_CALL
RV_EVT_CALL_STATE_CHANGED
RV_EVT_CALL_NEW_CHANNEL
RV_EVT_CHANNEL_PARAMETERS
RV_EVT_CHANNEL_SET_ADDRESS
RV_EVT_CHANNEL_SET_RTCP_ADDRESS Specifies the address to which RTCP
RV_EVT_CHANNEL_STATE_CHANGED
RV_EVT_CALL_NEW_RATE
RV_EVT_CALL_CAPABILITIES
RV_EVT_CALL_FACILITY
RV_EVT_CALL_CAPABILITIES_RESPONSE Reports the response of the remote
RV_EVT_CALL_MASTER_SLAVE_STATUS
RV_DROP_CALL
RV_EVT_NEW_CALL
RV_EVT_CALL_FASTSTART_SETUP
RV_EVT_CALL_INFO
RV_ANSWER_CALL
RV_SEND_CALL_STATUS_ENQUIRY
Table 4-18: H.323 Messages
H.323 Message
VOIP Maintenance and Troubleshooting
Descriptions
Make a new call with specified IP:Ext
Reports changes in call state (dialtone,
proceeding, alerting, etc.)
Reports that there has been a request
to open an incoming channel
Specifies parameters for a new
channel (G.723.1, G.711, G.729, etc.)
Specifies the address to which the
outgoing media stream should be
sent
packets should be sent
Channel state has been changed
(connected, idle, disconnected, etc.)
Reports changes in call rate
Reports changes in the remote party's
capabilities
Reports a facility message has arrived
system to the capabilities that have
been sent
Reports the response of the remote
system to the master/slave inquiry
Disconnect a call
Reports an incoming call
Reports the attempt of the remote
station to use the fast start procedure
Reports incoming call parameters
Answers current incoming call
Sending Status Enquiry message to
remote