Headset Installation; Caller Id Interface Unit Installation; Selecting The Cable - Vodavi STARPLUS Triad XTS Installation Manual

Headset Installation

Headset Installation
The XTS
standard electret mic compatible modular headset adapters and operator headsets.
To modify an Electronic/Digital Key Telephone to support an external headset:
1. Plug the headset adapter cord into the vacant handset jack on the Key Telephone base.
2. Plug the telephone handset cord into the headset adapter box where indicated by the
headset manufacturer's instructions.
The Headset Operation must be enabled (refer to Station Programming). The station then has
the capability to enable/disable headset mode by dialing a code. When Headset mode is
active at the station, the ON/OFF button controls the on-hook or off-hook status. Also,
features such as on-hook dialing and handsfree speakerphone operation become inoperable.

Caller ID Interface Unit Installation

The Caller Identification Interface Unit receives the data from the telephone company and
sends the data, in ASCII RS-232C format to a printer, telephone, computer or DTE (Data
Terminal Equipment) device.

Selecting the Cable

1. Select the correct cable for the MPB and SIU.
2. Connect one end of the cable on the desired KSU I/O port (1, 3, 4, or 5).
3. Connect the other end to the OUT port on the Caller ID unit. Use the adapter as necessary.
KSU
Electronic/Digital Key Telephones have been designed to operate with industry
To connect a 1480-00 caller ID box to the SMC1 connector of the MPB or to the SIU,
use cable P/N 9081-01.
To connect a 7480-00 caller ID box to the SMC1 connector of the MPB or to the SIU,
use the flat ribbon cable supplied and the 7481-10 adapter kit.
KSU 9-Pin
Female
1
2
3
4
5
6
7
8
9
Figure 3-43: 1480 Caller ID Cable Connections
MPB and SIU
1440/1480-00
Connection 9-Pin Male
1
2
3
4
5
6
7
8
9
Chapter 3 - System Installation
Caller ID Box
3-67