Rate (3.5.8.) - Siemens SITRANS LR460 Operating Instructions Manual

To change a breakpoint via the handheld programmer:
1. Confirm that Shaper Mode is selected.
2. Access the submenu for the breakpoint number in question and enter values for all desired
breakpoints.
3.5.7.1. Shaper A (1 - 9)
3.5.7.2. Shaper B (10 - 18)
3.5.7.3. Shaper C (19 - 27)
3.5.7.4. Shaper D (28 - 36)
3.5.7.5. Shaper E (37 - 45)
3.5.7.6. Shaper F (46 - 54)
3.5.7.7. Shaper G (55 - 63)
3.5.7.8. Shaper H (64 - 72)
3.5.7.9. Shaper I (73 - 81)
3.5.7.A. Shaper J (82 - 90)
3.5.7.B. Shaper K (91 - 99)
3.5.7.C. Shaper L (100 - 108)
3.5.7.D. Shaper M (109 - 117)
3.5.7.E. Shaper N (118 - 120)
8.5.5.7

Rate (3.5.8.)

Fill rate /min (FILL RATE) (3.5.8.1.)
Defines the maximum rate at which the reported sensor value is allowed to increase. Allows
you to further adjust the LR460 response to increases in the actual material level. Fill Rate is
automatically updated whenever Response Rate is altered.
Values
Altered by
Related
Enter a value slightly greater than the maximum vessel-filling rate, in Sensor Units per
minute.
SITRANS LR460
Operating Instructions, 10/2021, A5E42035355-AB
Range: 0.0000 to 99999 m / min.
Default: 10.000
Response Rate
Unit (Level)
High Level Point
Parameter assignment
8.5 Input (3.)
93