Table of Contents
Advertisement
1.
Check/Adjustment Procedures for Each Unit
Precautions for Check, Replacement, and Adjustment
In this volume, descriptions are omitted regarding components that do not require special
attention or adjustment during their removal/reinstallation. For removal procedures for such
components, refer to the Parts List Volume.
When performing check/replacement/adjustment procedures on the machine, the following
precautions should be observed.
WARNING
To avoid electric shock hazards, power OFF the machine before performing the
procedures.
WARNING/CAUTION
Observe the warnings and cautions described in the "Safety Precautions."
CAUTION
Never remove screws to which red paint is applied.
N INSTRUCTION N
Screws to which yellow paint is applied need to be adjusted at the time of component
installation. When installing a component, follow the specified check/adjustment
procedure.
Some of the illustrations in this volume contain check/adjustment and half-punch indicators
as needed.
For removal and reinstallation, perform the procedures as instructed by such indicators.
• Check/Adjustment indicator:
CHECK
• Half-punch indicator:
009-058-00
10.20.2000 FM2732 (2)
Indicates that it is necessary to check or adjust the
installation location when the part or component removed is
to be reinstalled.
This indicator is placed in the illustration that depicts the
procedures for removing the parts and components.
When you see this indicator, refer to its relevant "I Check/
Adjustment Procedures."
Indicates that it is necessary to align the half-punches when
installing the parts or components.
However, it is not indicated for the half-punches for
improving ease of assembly or preventing erroneous
assembly procedures.
CR-IR347 Service Manual
MC - 2
MC - 2
Advertisement
Table of Contents
