Table of Contents
Advertisement
I Check for Output Characters
Make sure that the output characters are indicated correctly on the output film.
N CHECKS N
• Make sure that the output characters are indicated correctly.
If anything abnormal is found, refer to "4. [2] CONFIGURATION SETTING" in the
"Maintenance Utility" volume.
• Ensure that there is nothing abnormal with the output characters.
If anything abnormal is found, refer to the "Troubleshooting" volume.
In normal two-image output mode
a
f
g
❍ Character display area A
(above the image area)
a: Hospital name
(institution name)
b: IP number
c: EDR mode and menu code
d: System ID and image number
009-058-03
08.30.2002 FM3476
Image
e
s
j
k
i
h
t
CR-IR347 Service Manual
Character display area A
Image
l
n
p
m
q
o
r
❍ Character display area B
(below the image area)
e: Image processing conditions
f: Exposure menu name
g: Standardization conditions
and amendments
h: Engineer code and exposure
table information
i: Department name
j: Patient ID
k: Patient name (kana)
l: Patient name (kanji)
m: Exposure date and time
n: Film mark
o: Sex
p: Age or birth date
q: Image reduction ratio
r: Set processing information
s: Left-right reversal mark ( )
t: Data compression code
u: PEM information or
Ene.-Sub./superposition
information
MC - 261.2
b
c
d
u
Character
display area B
R
FR7H6962.EPS
MC - 261.2
Advertisement
Table of Contents
