Sony HDC5500 Operating Instructions Manual page 53

OPERATION
Page name Item
Page No.
<EARPHONE> RECEIVE SELECT
24
INTERCOM
ENG
PROD
PGM1
PGM2
PGM3
TRACKER
SIDE TONE
OPERATION LINK
MIX TALK(INCOM1) or MIX
TALK(INCOM2)
<OPERATOR FILE> READ (USB t CAM)
25
WRITE (CAM t USB)
PRESET
*1 Observe the following points.
• When you turn D.EXTENDER ON or OFF, noise may be generated. This is not a malfunction. D.EXTENDER does not operate when 4K or
2× speed format is selected.
• TALLY R, TALLY G, and TALLY Y are enabled only in standalone mode.
• When HDLA is attached, VF DETAIL, SPIRIT LEVEL INDICATOR, and FOCUS ASSIST INDICATOR do not function.
• VTR S/S is available only when using the camera as a standalone device, and adds the REC signal to the SDI signal. Pressing this button
repeatedly toggles recording on/off. While recording, the tally lamp lights in red.
• An ":N/A" suffix is displayed for disabled items.
Settings
SEPARATE, MIX
---, LEFT, RIGHT, BOTH
---, LEFT, RIGHT, BOTH
---, LEFT, RIGHT, BOTH
---, LEFT, RIGHT, BOTH
---, LEFT, RIGHT, BOTH
---, LEFT, RIGHT, BOTH
---, LEFT, RIGHT, BOTH
MUTE, 1 to 99, 50
INCOM1, INCOM2
ENG, PROD
Execute using ENTER.
Execute using ENTER.
Execute using ENTER.
53
Description
Sets the headset audio.
SEPARATE: Set L and R separately.
MIX: Set L and R to the same settings.
UCJ model only
When the intercom Line select / Receive MIX select
switch selected by OPERATION LINK on the
operation panel is set to MIX, menu items ENG and
PROD appear instead of this item (the setting values
are same as this item).
CE model: Always displayed.
UCJ model: Displayed when the intercom Line select
/ Receive MIX select switch selected by OPERATION
LINK on the operation panel is set to MIX.
UCJ model: Selects which intercom to link to the
headset microphone on/off control, Line select /
Receive MIX switch, MIX TALK setting, and each
volume adjustment.
CE model: Selects which intercom to link to the
headset microphone on/off control and line
selection.
UCJ model only
Displays MIX TALK(INCOM1) when OPERATION LINK
is set to INCOM1, and MIX TALK(INCOM2) when set
to INCOM2.
Reads the operator file from a USB drive.
Writes the current settings of the operator file items
to a USB drive.
Sets the operator file items to the preset values in
internal memory.