BenQ Home Series User Manual page 60

Menu
3D
(Continued)
HDMI Settings
Reset Display
• The 4K source will not be displayed. When source is Media Reader, 3D mode is not supported.
• 3D Mode
The default setting is Auto and the projector automatically chooses an appropriate 3D format when
detecting 3D contents. If the projector cannot recognize the 3D format, press OK to choose a 3D mode from
among Frame Sequential, Frame Packing, Top-Bottom,and Side by Side.When this function is enabled:
• The brightness level of the projected image decreases.
• The Picture Mode cannot be adjusted.
• The 2D Keystone can only be adjusted within limited degrees.
• 3D Sync Invert
When your 3D image is distorted, enable this function to switch between the image for the left eye and the
right eye for more comfortable 3D viewing experience.
• HDMI Format
Selects a suitable RGB color range to correct the color accuracy.
• Auto: Automatically selects a suitable color range for the incoming HDMI signal.
• Limited: Utilizes the Limited range RGB 16-235.
• Full: Utilizes the Full range RGB 0-255.
• HDMI Equalizer
Sets a suitable value to maintain the HDMI picture quality in long distance data transmission.
• HDMI EDID
Switches between Enhanced for HDMI 2.0 EDID and Standard for HDMI 1.4 EDID. Selecting Standard which
supports up to 1080p 60Hz may solve abnormal display issues with some old players.
• Electronics Control
When connecting to HDMI CEC compatible devices to the projector with HDMI cables, these devices can be
controlled through the projector.
CEC function only support power on from device / power off from projector / power on ARC device / mute,
volume up, volume down ARC device.
• Power On Link / Power Off Link
When you connect an HDMI CEC-compatible device to your projector with an HDMI cable, you can set the
behavior of powering on/off between the device and the projector.
• Power On Link > From Device: When the connected device is turned on, the projector will be activated,
too.
• Power Off Link > From Projector: When the projector is turned off, the connected device will be shut
down, too.
Returns all the settings in the Display main menu to the factory default values.
Descriptions
60