Advertisement
FRONTIER
®
400X
BATTERY CONNECTION
CAUTION
Use caution as the electrolyte is a strong acid that can burn
skin and damage eyes.
®
The Frontier
400X is shipped with the negative battery cable
disconnected. Make certain that the RUN/STOP/IDLE switch is in
the STOP position. Remove the four screws from the battery tray
using a screwdriver or a 3/8"(10mm) socket. Attach the negative
battery cable to the negative battery terminal and tighten using a
1/2"(13mm) socket or wrench.
NOTE: This machine is furnished with a wet charged battery; if
unused for several months, the battery may require a booster
charge. Be careful to charge the battery with the correct polarity.
(See Battery in MAINTENANCE section)
WARNING
GASES FROM BATTERY can
explode.
•
from battery.
To prevent EXPLOSION when:
•
INSTALLING A NEW BATTERY — disconnect negative
battery last.
•
CONNECTING A BATTERY CHARGER — remove
battery from welder by disconnecting negative cable
reinstalling, connect negative cable last. Keep well
ventilated.
•
USING A BOOSTER — connect positive lead to battery
at engine foot.
BATTERY ACID can burn eyes and skin.
• Wear gloves and eye protection and be careful
when working near battery.
• Follow instructions printed on battery.
IMPORTANT: To prevent ELECTRICAL DAMAGE WHEN:
a) Installing new batteries.
b) Using a booster.
Use correct polarity — Negative Ground.
EXHAUST OUTLET PIPE
Using the clamp provided secure the outlet pipe to the outlet tube
with the pipe positioned such that it will direct the exhaust in the
desired direction away from the air intake. Tighten using a
wrench (See Figure A.3).
SPARK ARRESTOR
Some federal, state or local laws may require that gasoline or
diesel engines be equipped with exhaust spark arrestors when
they are operated in certain locations where unarrested sparks
Spark Arrestor.
AIR CLEANER SERVICE INDICATOR
Air cleaner service indicator provides a Go/No-Go visual indication
service door.
FIGURE A.3
EXHAUST OUTLET
A-5
INSTALLATION
EXHAUST CLAMP
Advertisement
