Table of Contents
Advertisement
Configuration
4.11 Maintenance
4.11.6
Communication / Restart
Process communication / Restart
On this page, you can stop or start the communication between gateway and process
stations and initiate a restart of the application.
With each command, a message is output by the system and the displayed status is
updated.
Process communication
The current status is displayed under "Status".
● Stop
Click the button to stop communication.
The labeling of the button changes.
● Start
Click the button to restart communication.
Restart
● Restart
Click the button to initiate a restart of the application.
Reset to factory settings
Here, you can reset the application to factory settings.
Note
Data loss due to reset
Before you reset, note the effects of the reset described below.
• All configuration data, certificates, keys and user data are deleted by the reset.
The data on an optional CLP are deleted as well.
• By resetting the IP parameters at the respective interface, the application can no longer
be reached using the previously configured address data.
The application can be reached at the factory set IP address of the respective interface.
For information on the preset IP parameters, see section Restarting and resetting
(Page 122).
The MAC addresses of the interfaces are not deleted by the reset.
● Reset
By clicking the button, you reset all data of the application to the factory settings.
After the reset, the application performs a restart.
118
Operating Instructions, 10/2019, C79000-G8976-C503-02
SIMATIC CC7
Advertisement
Table of Contents
