80 Chapter 2 Breaker interface panel
241-1501-200 5.2S2
The power output cables from the rear of the BIP to the parts of the shelf
include:
•
two 1x4 MATE-N-LOK II connectors with louvertec contacts for cables
providing power output to the PIMs in the shelves
•
one 1x2 MATE-N-LOK II connector with louvertec contacts for cables
providing power output to either the upper or lower cooling unit
The power output cable assemblies are always installed for both shelves even
if only one is mounted in a NEBS 2000 frame. For the cable connection
points, see the figure "Location of power output cable connectors at rear of
two shelves" (page 82).