Nortel Passport 15000 Hardware Description page 188

188 Chapter 4 Control and function processors
241-1501-200 5.2S2
The table "Cable assemblies for a DS3 FP" (page 188) lists the available
prefabricated cables.
Table 35
Cable assemblies for a DS3 FP
PEC Description
NTHR58 DS3 male 8W8 mini-coax to male BNC
NTHR59 DS3 male 8W8 mini-coax to male BNC
NTHR60 DS3 male 8W8 mini-coax to male BNC
NTHR72 DS3 male 8W8-to-8W8 male mini-coax
NTHR73 DS3 male 8W8-to-8W8 male mini-coax
NTHR74 DS3 male 8W8-to-8W8 male mini-coax
NTHR69 DS3 DB9 sparing control port
NTHR70 DS3 DB9 sparing control port
NTHR71 DS3 DB9 sparing control port
You can custom make your own control port cable using the following
specifications:
• tin-plated copper cable with 5 conductors at 7 strands of 32 AWG
2
(0.0320 mm ) wire for each conductor, with an aluminum polyester
shield, covered by poly vinyl chloride insulation (for example, Beldon
Wire and Cable part number 9535)
• a resultant cable size of 24 AWG (0.205 mm
• a 45-degree downwards offset female DB9 connector with standard
slotted fastening screws for the FP faceplate; see the orientation of the
sparing D-sub connector in the figure "Faceplate of a 12-port DS3 FP
with PEC NTHR23" (page 186) to determine the orientation of the
downwards offset relative to the shape of the D
• a straight male DB9 connector with standard slotted fastening screws for
the sparing panel faceplate
Length
2.5 m (8 ft)
5 m (16 ft)
15 m (49 ft)
2.5 m (8 ft)
5 m (16 ft)
15 m (49 ft)
2.5 m (8 ft)
5 m (16 ft)
15 m (49 ft)
2
)