Cleaning The Hot Water Nozzle; Descaling - DeLonghi DINAMICA PLUS ECAM37 95 Series Instructions For Use Manual

5. Make sure there are no milk residues on the hollow and
groove under the dial. If necessary, scrape the groove with
a toothpick (fig. 31);
6. Check that the intake tube and spout are not clogged with
milk residues;
7. Dry all the components with a clean dry cloth;
8. Reassemble all the lid components;
9. Attach the lid back on the milk container.

13.11 Cleaning the hot water nozzle

Each time you prepare milk, clean the connection nozzle (A8)
with a sponge to remove milk residues from the gaskets (fig.
20).

14. DESCALING

Important!
• Before use, read the instructions and the labelling relative to
the descaler product, which are indicated on the pack (includ-
ed with certain models and/or available for purchase from
authorized service centres).
• Use De'Longhi descaler only. Using unsuitable descaler
and/or performing descaling incorrectly may result in
faults not covered by the manufacturer's guarantee.
Descaler could damage delicate surfaces. If the product is
accidentally spilt, dry immediately.
To descale
Descaler De'Longhi "EcoDecalk" descaler
Container Recommended capacity: 2.0
Time ~45min
Descale the appliance when "DESCALING NEEDED" "PRESS OK
TO START (~45min)" appears on the display: To descale the
appliance immediately, press
erations from point 3.
To descale the appliance later, press
symbol (B7) appears on the display to remind you that the ap-
pliance needs descaling. (The message appears each time you
turn the appliance on).
To access the descaling menu:
1. Pressthe "
2. Press "DESCALE" and follow the instructions on the
3. "REMOVE WATER FILTER" (fig. 33): extract the water tank
32
4. "DESCALER (LEVEL A) AND WATER (LEVEL B)". Pour the des-
5. "EMPTY DRIP TRAY" (fig. 21):
6. Remove, empty and replace the drip tray (A15) and
7. "POSITION 2l CONTAINER" "OK TO START":
Place an empty container with a minimum capacity of 2 litres
under the hot water spout (D6) and coffee spouts (A9);
17
" button (C3) to enter the menu;
display;
(A17), remove the water softener filter (D6) (if present)
and empty the tank. Press
caler into the tank up to level A (corresponding to a 100ml
pack) marked on the inner surface of the tank (fig. 34),
then add water (one litre) up to level B (fig. 35) and put the
water tank back. Press
grounds container (A11). Press
B
A
A
34
and follow the op-
. The
;
33
;
;
B
A
B
35